Guide: Adding an Analog Device to the BG-COMMANDER

Follow these steps to set up and control an analog camera:

1. Switch to Analog Mode

• Long-press the button on top of the joystick handle.
• This toggles the controller into Analog Mode.

2. Open the Setup Menu

• Press the [SETUP/MENU] button.
• Navigate to Add Analog Device.

3. Add an Analog Camera

Inside the device adding interface:

1. Select Camera Number
   
   • Choose which camera slot (1–7) you want to assign the analog device to using the number keys.
     
     
2. Set Protocol
   
   • Select the correct protocol for your camera (e.g., PELCO-D or VISCA).
     
     
3. Set Address Code
   
   • Enter the camera’s address (e.g., 1, 2, 3… as set on the camera).
   • This ensures the controller communicates with the correct device.
     
     
4. Set Baud Rate
   
   • Choose the baud rate to match the camera (default is usually 9600).

4. Confirm Settings

• Press the [ENTER] key to save.
• The analog device will now be active and controllable under the assigned camera number.

✅ Tip: Ensure the wiring is correct between the controller’s RS-485/RS-232 output and the analog camera’s control input before starting configuration.